How to Attach a Flight Shoulder Harness to Your Pack

Quick answer

Attach the Flight Shoulder Harness by threading the pack's webbing through the harness channels, securing the sternum strap, and adjusting the load lifters for your torso length.

Step-by-step attachment process

1. 1. Locate the attachment slots: On your Flight Series pack, find the two vertical webbing channels on the back panel where the harness connects. These are typically at the top of the frame, near the load-lifter attachment points. Check that the harness's webbing straps are not twisted before threading.
2. 2. Thread the harness webbing: Insert the top of the shoulder harness strap into the channel, pushing it through until the buckle end emerges at the bottom. Repeat for the other side. Ensure the harness sits flat against the pack. If the strap doesn't slide easily, don't force it—gently wiggle it through to avoid damaging the fabric.
3. 3. Secure the harness buckles: Clip the harness buckles into the corresponding female buckles at the bottom of the pack's frame. You should hear a distinct click. Tug gently to confirm they are locked. A loose buckle can cause the harness to detach under load. Double-check each connection.
4. 4. Adjust the sternum strap: Slide the sternum strap up or down along the harness's webbing to a comfortable position across your chest. Fasten it and adjust the tension so it sits snug but not restrictive. Position the sternum strap about 1-2 inches below your collarbone for optimal load transfer.
5. 5. Set the load lifters: Connect the load-lifter straps from the top of the pack to the harness's attachment points. Tighten them evenly so they angle back at about 45 degrees, pulling the pack close to your body. Over-tightening load lifters can lift the pack off your shoulders, creating a gap. Aim for a snug, even pull.
6. 6. Test and fine-tune fit: Put on the pack with some weight. Walk a few steps and check for pressure points or shifting. Adjust the sternum strap and load lifters as needed. The harness should feel secure without digging in. If the harness feels loose after adjustment, revisit the webbing threading—it may have slipped during initial setup.

Product facts

• Flight Shoulder Harness (Closeout): The Flight Shoulder Harness features sliding sternum straps and two 4-way stretch pockets that can hold 500ml soft bottles. The sliding sternum strap lets you fine-tune the chest position for comfort, while the stretch pockets keep water or small gear within easy reach without unclipping the harness.